Bluemont is please to announce US based Advanced MikroTik RouterOS Training. This 4-day training class is for new ISPs, network engineers and system integrators who would like to learn more about using MikroTik RouterOS for general or dynamic routing, bandwidth management, HotSpot systems, wireless access points and backbones.

Price for this course is $950 USD.

Certification 

At the end of the 4-day training participants can attend Mikrotik RouterOS Certification Test. The test will start at 3:30pm on the fourth day of training and will take no more than 1h30m. A Certificate will be issued to those who successfully pass the test.

Location

Training will be in a site to be finalized in Sterling, VA, five minutes from the Washington Dulles Airport. 

Travel and Visas

We cannot assist you with the travel arrangements and entry permits to the US. For hotel information in the Dulles, VA area, please click here.

Registration

Starts promptly at 8.00am on the first day of training.

Training Schedule 

Training Classes start at 9am each day and end at 5pm.

Refreshments 

Refreshments, Coffee and Lunch are provided to all participants free of charge.

Payments

Your registration is not complete and the seat is not guaranteed until the payment is received in full. There is a big demand for this training, and seating is limited, therefore we suggest that you do not delay with the payment. If any discount applies, the payment should be received prior the discount deadline.  

Cancellations

In case you need to cancel your participation at the training, a written notice should be sent by e-mail to   This e-mail address is being protected from spam bots, you need JavaScript enabled to view it This e-mail address is being protected from spam bots, you need JavaScript enabled to view it   prior to the class. There is an administrative fee of US$100 for refunds that are 30 days prior to the class. There is no refund for training fees if cancellation is received during the last 30 days before the class.

Course Prerequisites:

1) Each participant will be provided with RouterBoard to work with during the class. You should bring your own laptop computer equipped with Ethernet port (required), Serial COM port or USB to Serial adapter (recommended) and IEEE 802.11b standard wireless card (recommended)

2) Basic knowledge of TCP/IP and routing. We will be expanding on this during the course, but we suggest that the participants take the online TCP/IP Basics course before attending the class.

3) Basic knowledge of wired and wireless networking.

Click Here To Sign-Up For Training Now 

We reserve the right to refuse registration and admission to any person without assigning any reason.

Directions to CIT

Center for Innovative Technology
2214 Rock Hill Road, Suite 600
Herndon, VA 20170-4200
703/689-3000 FAX: 703/689-3041

From Central VA:

1. I-66 E to Exit 53. Sign reads: “Rte. 28 Dulles Airport.”
2. Proceed North on Rte. 28 (Sully Road) for 9 miles.
3. After crossing the Dulles Access Road and the Toll Road (Rte. 267), take the exit for Rte. 606 East (Old Ox Road) and follow to the second traffic signal (Rock Hill Road).
4. Make a RIGHT onto Rock Hill Road and follow approximately 1 mi. to a three-way stop.
5. Make a RIGHT at the stop sign, go approximately 50 yards and turn LEFT into the entrance driveway for CIT.
6. Enter the first garage opening marked “Visitors.”
7. Take elevator to Commons area (Level *1) and proceed to the Reception Desk for further directions.

From Dulles Airport:

1. Rte. 267 East (Toll Road to Washington) to Exit 9B. Sign reads: “Rte. 28 North to Rte. 7 Leesburg.”
2. After crossing the Dulles Access Road and Toll Road (Rte. 267), take the exit for Rt. 606 East (Old Ox Road) and follow to second traffic signal (Rock Hill Road).
3. Make a RIGHT onto Rock Hill Road and follow approximately 1 mi. to a three-way stop.
4. Make a RIGHT at the stop sign, go approximately 50 yards and turn LEFT into the entrance driveway for CIT.
5. Enter the first garage opening marked “Visitors.”
6. Take elevator to Commons area (Level *1) and proceed to the Reception Desk for further directions.

From Dulles Greenway:

1. From the Dulles Greenway, travel east to Exit 8, Old Ox Road, (Rte. 606 East).
2. Turn LEFT onto Rte. 606.
3. Follow Rte. 606 to Rock Hill Road.
4. Make a RIGHT onto Rock Hill Road and follow approximately 1 mi. to a three-way stop.
5. Make a RIGHT at the stop sign, go approximately 50 yards and turn LEFT into the entrance driveway for CIT.
6. Enter the first garage opening marked “Visitors.”
7. Take elevator to Commons area (Level *1) and proceed to the Reception Desk for further directions.

From Richmond VA:

1. I-95 N to I-495, Exit 170B. Sign reads “North Tysons Corner, Exit 170B.”
2. I-495 for 11 miles to left-hand exit, Exit 45. Sign Reads: “Rte. 267 W Toll Road/Dulles Airport.”
3. Take Rte. 267 W Toll Road To All Local Exits.

**DO NOT TAKE DULLES AIRPORT ACCESS ROAD. **

1. Follow Rte. 267 W Toll Road to Exit 9B (Rte. 28 N).
2. Stay RIGHT and turn RIGHT onto Rte. 28 N (Sully Road).
3. Follow Rte. 28 N. until exit for Rte. 606 East (Old Ox Road)
4. Follow Rte. 606 East to the second traffic signal (Rock Hill Road).
5. Make a RIGHT onto Rock Hill Road and follow approximately 1 mi. to a three-way stop.
6. Make a RIGHT at the stop sign , go approximately 50 yards and turn LEFT into the entrance driveway for CIT.
7. Enter the first garage opening marked “Visitors.”
8. Take elevator to Commons area (Level *1) and proceed to the Reception Desk for further directions.

From Route 7:

1. Take Rte. 28 S (Sully Road), to exit for Rt. 606 East (Old Ox Road)
2. At the second traffic signal (Rock Hill Road), make a RIGHT onto Rock Hill Road and follow and follow approximately 1 mi. to a three-way stop.
3. Make a RIGHT at the stop sign, go approximately 50 yards and turn LEFT into entrance driveway for CIT.
4. Enter the first garage opening marked “Visitors.”
5. Take elevator to Commons area (Level *1) and proceed to the Reception Desk for further directions.

From Washington DC:

1. I-66 W to Exit 67. Sign reads: “Dulles Airport To I-495 N Baltimore.”
2. Follow signs for Rte. 267 W Toll Road to All Local Exits.

**DO NOT TAKE DULLES AIRPORT ACCESS ROAD. **

1. Rte. 267 W Toll Road to Exit 9B.
2. Stay RIGHT and turn RIGHT onto Rte. 28 North (Sully Road).
3. Follow Rt. 28N until the exit for Rt. 606 East (Old Ox Road)
4. At the second traffic signal (Rock Hill Road), make a RIGHT onto Rock Hill Road and follow and follow approximately 1 mi. to a three-way stop.
5. Make a RIGHT at the stop sign, go approximately 50 yards and turn LEFT into entrance driveway for CIT.
6. Enter the first garage opening marked “Visitors.”
7. Take elevator to Commons area (Level *1) and proceed to the Reception Desk for further directions.